A compact, purpose-built insert for travel and quick deployment. If you carry a pair of Grabo or Grabo Pro units, this fitout turns a single Systainer³ M 237 into a ready rack so swaps are automatic and batteries live where you expect.
What's included
- Fitout insert designed for Systainer³ M 237
- 2× Grabo/Pro saddles with magnetic retention
- 2× battery bays
- TPU protective saddles
Availability: Order as insert-only or as a complete fitout bundled with a FORG3D Edition Systainer³ M 237
Best for
- Installers moving between jobsites
- Finish carpenters needing quick setup
- Mobile rigs where space and speed matter
- Anyone who wants Grabo units protected and instantly accessible
Installation steps
- Seat the insert Place the fitout insert into your Systainer³ M 237 shell. Check that it sits flush and doesn't interfere with latch clearance.
- Fit TPU saddles Position the TPU saddles into their designated slots. Confirm that the magnets engage properly with your Grabo units.
- Load batteries Place batteries in the battery bays with terminals facing outward for quick swaps during use.
- Test fit your Grabo units Place both Grabo or Grabo Pro units in their saddles. They should sit securely with magnetic retention holding them in place.
- Close and test Close the Systainer lid and verify there's no interference. Open and test that you can grab a unit quickly.
Compatibility notes
- Compatible with: Grabo and Grabo Pro handheld units
- Not compatible with: Nexus (see SYS-FIT Nexus Dock for Nexus storage)
- Container: Systainer³ M 237 only
Care & maintenance
After transport:
- Wipe TPU saddles clean of dust or debris
- Check magnet seating — reseat if units feel loose
Quarterly:
- Inspect TPU for wear or cracking
- Verify magnetic retention strength
As needed:
- Replace worn saddles to maintain protection
Next steps
- Pair with SYS-ORG PodBins to keep small accessories sorted
- See SYS-FIT Overview for choosing between fitout options
- Browse SYS-FIT FAQ for build-your-own tips
Powered by