When your Nexus is your daily interface, storage should keep it ready as a single unit — no re-rigging between jobs. This dock is designed to store the Nexus with a Grabo or DeWalt Grabo attached so the whole assembly lifts in and drops out together.
What's included
- Fitout insert designed for Sortainer 2 (M 337) lower drawer
- Protective compartment for Nexus baseplate with attached Grabo or DeWalt Grabo
- Compartment for SYS-GRP Minimus Bracket
Best for
- Crews who move between bench, cart, and site
- Anyone who wants one-piece grab-and-go Nexus deployment
- Users who keep a Grabo permanently attached to their Nexus
- Shops that need staged vacuum source storage
Installation steps
- Place the insert in the lower drawer Take the provided fitout insert and place it in the lower (large) drawer of your Sortainer/2 (M 337).
- Prepare your unit for storage DeWalt Grabo: Remove the battery before placing in the compartment — the drawer will not close with the battery installed. Grabo Pro-Lifter: Battery can remain in place during storage.
- Position your Nexus Place the Nexus with attached Grabo into the insert compartment. The Grabo handle should have clearance and not interfere with the drawer.
- Add Minimus Bracket (optional) If using a SYS-GRP Minimus Bracket, place it in the dedicated compartment.
- Store accessories in the upper drawer Use the upper drawer of the Sortainer/2 to store hoses, valves, fittings, and other vacuum system accessories.
- Test the setup Close the Sortainer and verify latches engage properly. Open and test that you can lift the Nexus + Grabo as a single unit.
Systainer sourcing
Source the Sortainer/2 (M 337) from Systainer Store at this time, or use one you already have on hand.
System pairing tips
Fun note: When paired with a set of SYS-ORG PodBins, this fitout really "sucks" — the pods and Grabo stay ready and the smalls stay sorted.
Consider organizing your Nexus Dock alongside:
- SYS-ORG PodBins for small fittings, gaskets, and spare parts (upper drawer storage)
- SYS-GRP Pod Dock for AnchorDogs and rail inserts
- SYS-FIT Grabo Fitout for backup handheld units
Care & maintenance
After each use:
- Wipe insert clean of debris
Quarterly:
- Inspect insert for cracks or compression
- Clean compartment well
Next steps
- See SYS-FIT Overview for choosing between fitout options
- Explore SYS-GRP AnchorPod for vacuum workholding options
- Browse SYS-FIT FAQ for maintenance schedules
Powered by