Top-mount single pod configuration
What's Included
With your SYS-GRP Shaper Plate Maximus Vacuum pod package, you'll receive:
- SYS-GRP Shaper Plate Maximus Vacuum pod
- M5 × 0.8 mm fasteners
What You'll Need
From the package:
- SYS-GRP Shaper Plate Maximus Vacuum pod
- Supplied M5 × 0.8 mm fasteners
Tools (not supplied):
- 4 mm hex drive bit or Allen wrench
- Cup of coffee or other adult beverage
Additional equipment:
- Shaper Origin Shaper Plate
- Vacuum source (Grabo + Nexus or dedicated pump)
- 1/4" vacuum tubing
Installation Steps
Take the provided M5 × 0.8 mm fasteners and insert them into the integrated brackets of the SYS-GRP Shaper Plate Maximus Vacuum Pod.
Place the Maximus pod at the top of the Shaper Plate.
Align the M5 fasteners with the upper threaded mounting holes on the Shaper Plate.
Tighten the M5 fasteners with a 4 mm hex drive bit or Allen wrench.
Connect the SYS-GRP Shaper Plate Maximus Vacuum pod to your vacuum source using 1/4" tubing.
- Place a workpiece on the Shaper Plate
- Engage vacuum and verify seal
- Test hold strength before beginning work
Take a drink of your beverage and prepare to use the SYS-GRP Shaper Plate Maximus Vacuum pod on your workpiece.
Maximus Pod Specifications
Mounting style: Top-mount
Pod count: Single pod
Footprint: Integrated brackets for direct mounting
Best for: Single-point workholding on Shaper Plate
Next Steps
Need help with vacuum sources or troubleshooting? Check out our SYS-GRP General guides for vacuum source options, manifold setup, and troubleshooting tips.
Powered by